Table of Contents
Advertisement
steel/aluminum and trace downward until the panel meets up with the lower portion of the footbox
aluminum.
Remove the vinyl and cut along the line you just made.
Put the vinyl back on the tunnel, taping the top edges to hold the vinyl in position.
When cutting the material, do not cut too far! The material may be higher or lower once glued in
place and if you cut too far, the slit may be visible, so make your cut a bit short to begin with.
Once the material is glued in place, you can extend the cut if needed.
Cut the portion of the footbox floor underneath the gas pedal.
Cut the location where the floor drops and begins the footbox.
568
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
