License Plate Lights - Factory Five Racing GTM Supercar Assembly Manual

License Plate Lights


3 / ", 5 " drill bits, drill, Rivet gun, ½" wrench,
/
16 16

License Plate Lights.
Center the license plate in the recess and mark the two upper holes.
Use a 5 / " drill bit and drill out the two holes.
16
Place the license plate into position and slide the light through the plate, then the body.
Make sure you put the nut on before soldering the wires.
3 / " Hex key, wire strippers, solder, soldering gun
16
676
www.factoryfive.com 508-291-3443