Rear Splash Guards - Factory Five Racing GTM Supercar Assembly Manual

Rear Splash Guards


Eye protection, drill w/#6 hex nut driver, ⅛",
#6 self tapping screws.

Rear Splash Guard Assembly (FFR# 25688).
The process for installing the rear splash guards is the same for both driver and passenger side (all
pictures below were taken from passenger side). Make sure that the front lower splash guard is installed as
previously instructed (FFR# 25651 and 25655).
Attach Bulb seal to each aluminum panel where it contacts the body. Look at the pictures below to see
which panels to install the bulb seal to. Trim the bulb seal slightly longer than needed to prevent gaps.
3 / " drill bits, drill, rivet gun, silicone, caulking gun,
16
664
www.factoryfive.com 508-291-3443