Weatherstripping; Final Body Mounting - Factory Five Racing Type 65 Coupe Assembly Manual

Line up the mesh on the nose and tape them in place to hold them until the silicone dries (usually over
night).

Weatherstripping


Razor knife, tin snips

Secondary body fasteners
Replace any weatherstrip that was damaged during body removal.
Put additional weatherstrip on the frame where gap areas were noted before paint.

The expanding foam weatherstrip is unique in that it has an adhesive side and it expands from ½"
tall to 2" tall over 24 hours. Us this weatherstrip anywhere there were larger gaps or you think
extra weatherstrip is needed.

Final Body Mounting

Using two people, one on each side holding the wheel well and side exhaust recess move towards the
frame from the rear with the back slightly lower than the front.
339
www.factoryfive.com 508-291-3443