Drill 4 holes in the headlight bucket. From the backside of the headlight bucket, use the headlight cutout
template (FFR# 25484) and mark the 4 locations using a paint marker. (at this time the lights should not
be installed in the buckets)
Using a
25
/
" drill bit, drill
3
/
" into the headlight bucket from the backside. You will drill through a layer
64
8
of fiberglass and then into a foam core, stop there, do not go through the second layer of fiberglass.
Press the black retainer clips over the ball fittings attached to both the head light and high beam light.
515
www.factoryfive.com
508-291-3443