Factory Five Racing GTM Supercar Assembly Manual page 505

Squeeze a small amount of the supplied adhesive (FFR# 25865) onto a flat surface like a piece of
cardboard (something you are willing to discard). The epoxy is a two part epoxy, so be sure that both
parts A and B are coming out of the tube. Mix part A and B together with a nail, rivet or something
similar (also something you are willing to discard). Once mixed, you should have a pool of adhesive
about the diameter of a quarter and about ⅛" –

When applying the adhesive to the brackets, if the location on the track that you will bond the
bracket to has a hole, place a piece of duct tape over the hole on the backside of the track to
prevent the adhesive from seeping through the hole (if the adhesive seeps through the hole and is
allowed to harden, it can interfere with the window guide movement).
Apply to the back of one the supplied Window Track Brackets.
Using a set of clamps and a small straightedge, clamp the bracket to the window track and allow the
adhesive to harden (Driver side rear shown). Repeat for front bracket.
3 / " thick.
16
496
www.factoryfive.com 508-291-3443