Table of Contents
Advertisement
Remember to work carefully! After spraying the adhesive and wrapping the material around the
roll bar and overlapping it at the top of the roll bar, tape the cover in place with masking tape until
the adhesive dries.
When removing the tape, do not begin pulling the tape at the cut edge – you will pull the material
away from the foam. Instead, peel the tape back so that the last bit of tape in contact with the
material is at the cut edge of the material.
Again, begin with the front upper bend of the side bar (the top of the A-pillar), remove the tape holding
the material on from the trial fit.
Spray some of the headliner adhesive on the backing of the material, and then wrap the cover around the
roll bar. Make sure to spray the underside of the cover material so it will adhere to itself once you begin
to overlap the material.
553
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
