Hazard Wiring - Factory Five Racing GTM Supercar Assembly Manual

L Tan
M ----
N Black
P ----
R Brown
S White
T Dark green
U Orange
V Black
W Red
X Red
Y Light Blue
Z Orange
*The dark green and dark blue wires from the Painless harness need to be spliced into the dark green wire
on the Corvette harness (Pin B). Similarly, the yellow and light blue wires from the Painless harness need
to be spliced into the yellow wire of the Corvette harness (Pin C). These wires will allow proper function
of the Hazard lights.

Two circuits from the chassis harness will not be used and should be taped off. The white brake
switch to turn signal switch wire and the Blue/Yellow dimmer switch wire.

Hazard Wiring


Wire crimper, wire stripper

Dash components, misc. electrical
Strip and connect the wires to the switch connectors.
Connect the switch wires.
Headlight Low Beams
Not used
Ground
Not used
Parking/Dash Lights
Headlamp switch, on
Headlamp switch, off
Corner lamp feed, left
Horn relay output
Battery Positive
Battery Positive
Park lamp switch output
Battery Positive
335
www.factoryfive.com 508-291-3443
Black (relay #86) from low beam
relay (white wire (relay #30)
input is #909)
Ground
Black (relay #86) from parking
relay (white wire (relay #30)
input are 927 and 929)
Black from painless horn relay
Red/black 928
Red/black 928
Orange 959