Remove the console again!
Cut the cover material on the line you marked so that it will not get messed up by a saw blade.
Use a jig saw or similar to trim the area marked.
Re install the console and recheck the handle for clearance. Trim again if necessary.
The center console can be attached to the frame a number of different ways. Factory Five has
provided washer head sheetmetal screws, an alternative would be to use the 10-32 rivnuts.
Drill three evenly spaced holes through the side flanges of the center console and the 1" square steel
tubes.
685
www.factoryfive.com
508-291-3443