Factory Five Racing GTM Supercar Assembly Manual page 442

Route the braided line along the 1.5" square tube between the engine mount brackets, making sure that it
is low and away from the exhaust, crank pulley, A/C Compressor etc. Check for kinks in the line.
Install the other elbow onto the braided hose.
Thread the hose onto the bulkhead fitting you installed in the other tank.

Check for leaks before fastening the lines to the chassis. Once you are sure the line isn't kinked
and is safely out of the way of any moving parts and none of the fittings are leaking, secure the
line to the chassis using the supplied insulated hose clamps and rivets.
Using the flexible fuel hose supplied with the GTM kit, connect the barbed fitting on the top of the
sending unit to the fuel rail on the engine.
Plug in the electrical connections for the Fuel Pump and Sender assemblies and the fuel tank pressure
switch.
433
www.factoryfive.com 508-291-3443