Knee Bolster - Factory Five Racing GTM Supercar Assembly Manual

Knee Bolster


Flathead Screwdriver, T-15 Torx.
Remove console and trim plate if you haven't done so already.
Remove the Fog lamp/Trunk Release switch – pry at the bottom to release. Disconnect the electrical
plug.
Unscrew the retaining bolt behind the switch, and the two screws under the knee bolster (T-15 Torx).
Lift firmly at the sides pulling rearward. Disconnect the Inside Air Temperature sensor (if equipped).
89
www.factoryfive.com 508-291-3443