Table of Contents
Advertisement
Set the engine cover in place, and fasten it to the rear wall with the supplied ¼"-20 bolts (4 mm Hex).
Before drilling, make sure the engine cover is pressed onto the top of the steel it surrounds at the bottom
end. Then, using the holes you already drilled in the engine cover, drill ¼" holes in the frame. A good
way to prevent the engine cover from moving as you drill each hole is to drill the first hole, place one of
the ¼"-20 bolts in the hole, move on to the next hole, place a ¼"-20 bolt in it etc.
594
www.factoryfive.com
508-291-3443
Advertisement
Table of Contents
