Factory Five Racing GTM Supercar Assembly Manual page 568

Begin to wrap the vinyl around the aluminum, pressing first along the sides of the aluminum. Then press
the vinyl over the back of the aluminum until each section of vinyl sticks to the panel with no wrinkles.
Using the holes you already punched as a guide, punch holes through the vinyl you just wrapped around
the aluminum. You will want to punch through each hole in a few different directions (North to South,
East to West for example) to allow the bolt to go through. Check the fit with one of the bolts by pressing
it (you may have to use a Hex key to tighten it down) through the hole. If necessary, cut the vinyl as
needed to get the bolt through.
559
www.factoryfive.com 508-291-3443