Wipers - Factory Five Racing GTM Supercar Assembly Manual

From the latch support side insert the ¼"-20 x 1.00" flange head screws through the latch support, body,
latch spacer and into the latch.
Tighten the screws.
Insert the hatch release cable end fitting into the latch spacer.
Insert the cable into the swivel wire stop.
Pull on the end of the cable and, at the same time, tighten the release cable in the swivel wire stop.
Leaving the hatch open, test the release cable. If necessary either loosen and readjust the cable in the
swivel fitting or loosen the latch screws and adjust the latch spacer so the cable is tight.
Close the hatch and test the release cable. If necessary, move the shoulder bolt up or down so that the
hatch is flush with the body.

Wipers

On the cowl measure straight back ¾" from the bottom point of the driver's side wiper pad and mark a
point.
Drill this point with a 1" drill bit or hole saw.
465
www.factoryfive.com 508-291-3443