Drive/Test Chassis (Go-Cart)
Front Suspension
Now is a good time to double check all your hardware, make sure your wiring and hoses are away from
extreme heat and moving parts, make sure the steering turns freely lock to lock, and make sure your brake
flex lines have enough slack for the full range of wheel movement.
Fluid Levels and Grease
Grease gun, chassis grease, ratchet, rags
Transmission fluid, rear axle gear oil, engine oil, coolant, water
Transmission
Fill the transmission with fluid and install the shifter assembly. Leave the shift handle and knob off for
now.
Engine
Fill the engine with Oil and coolant. Both these fluids should be rechecked after you have started the
engine for the first time. Make sure there is some coolant in the overflow to start out, about
Suspension
All of the suspension and steering components that have grease fitting need to be greased. With a grease
gun squeeze grease into each fitting on all the control arms, including rear lowers on a slid axle, and tie
rods.
435
www.factoryfive.com
508-291-3443
1
/
full is good.
3