Factory Five Racing GTM Supercar Assembly Manual page 503

Place the lower portion of the rear track into the molded recess on the inside of the door near the back of
the door.
Position the track so that the mounting hole in the track is in the approximate location shown in the
picture below (shown already bolted in position).
Drill a 6 mm (approx ¼" if you don't have a 6 mm drill bit) hole in the door pocket.
Bolt the track to the door with the supplied hardware (FFR# 25798), but do not fully tighten yet.
Adjust the tracks by pivoting them about the lower bolts. Start by positioning the rear upper track so that
the bolt will be approximately 10" from the rear edge of the door and the bolt in the front track will be
about 27" from the rear edge of the door.
494
www.factoryfive.com 508-291-3443