Factory Five Racing GTM Supercar Assembly Manual page 566

Remove the aluminum panel from the vinyl. If you have been working on a surface that you don't want
overspray on, use a box or something similar that you can set the vinyl on and not be concerned with
getting overspray on. Spray the vinyl with the Super 77, covering the entire piece.
Spray the side of the aluminum that was in contact with the vinyl when you marked and cut the material
to fit.
Carefully lower the aluminum panel back onto the vinyl, lining it up with the cuts you made.
Punch holes in the vinyl where the bolts will go through it with a Razor knife or something similar.
557
www.factoryfive.com 508-291-3443