Ricoh 920F Operating Instructions Manual page 1476

6. Managing Access to the Machine
5. Select Collect Job Logs to specify Job Log settings, or select Collect Access Logs to specify
Access Log settings, and then select [Active].
6. Specify the recording levels for either Job Log Collect Level or Access Log Collect Level.
The settings shown for "Job Log Collect Level" or "Access Log Collect Level" vary depending on the
collection level selected.
If you change the setting in the list, the setting for Job Log Collect Level or Access Log Collect Level
automatically changes to [User Settings].
7. Click [OK].
Changes are also reflected in related log settings.
8. Click [Logout].
• The greater the Access Log Collect setting value, the more logs are collected.
Disabling Log Transfer to Web SmartDeviceMonitor
6
Use the following procedure to disable log transfer to Web SmartDeviceMonitor. Note that you can change
the log transfer setting to [Inactive] only if it is already set to [Active].
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
The machine administrator can log on using the appropriate login user name and login password.
4. Click [Configuration], and then click [Logs] under Device Settings.
5. Select [Inactive] under "Transfer Logs".
6. Click [OK].
7. Click [Logout].
Specifying Log Encryption
Use the following procedure to enable/disable log encryption.
1. Open a Web browser.
154