Configuring Traffic Shaping; Configuring Port Rate Limiting - H3C S3100 Series Operation Manual

[Sysname] acl number 2000
[Sysname-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[Sysname-acl-basic-2000] quit
[Sysname] traffic-limit vlan 2 inbound ip-group 2000 128 exceed remark-dscp 56

Configuring Traffic Shaping

Only H3C S3100-EI series switches support this configuration.
Refer to section
Configuration prerequisites
The maximum traffic rate and the burst size are determined.
The port where traffic shaping is to be configured is determined.
Configuration procedure
Table 1-22 Configure traffic shaping
Operation
Enter system view
Enter Ethernet port view
Configure traffic shaping
Configuration examples
# Perform traffic shaping for all the traffic to be transmitted through Ethernet 1/0/1, with the maximum
traffic rate being 640 kbps and the burst size being 16 KB.
<Sysname> system-view
[Sysname] interface Ethernet1/0/1
[Sysname-Ethernet1/0/1] traffic-shape 640 16

Configuring Port Rate Limiting

Refer to section
argument is committed information rate (CIR).
Configuration prerequisites
The port on which port rate limiting configuration is to be performed is determined.
The target rate and the direction of rate limiting (inbound or outbound) are determined.
Traffic Policing and Traffic Shaping
system-view
interface interface-type
interface-number
traffic-shape queue
queue-id max-rate burst-size
Port Rate Limiting for information about port rate limiting. Note that, the target-rate
for information about traffic shaping.
Command
—
—
Required
Traffic shaping is not enabled by
default.
1-21
Description