Configuring The Management Device - H3C S3100 Series Operation Manual

Configuring the Cluster Synchronization Function

Configuring the Management Device

Management device configuration tasks
Complete the following tasks to configure management device:
Enabling NDP globally and on specific ports
Configuring NDP-related parameters
Enabling NTDP globally and on a specific port
Configuring NTDP-related parameters
Enabling the cluster function
Configuring cluster parameters
Configuring inside-outside interaction for a cluster
To reduce the risk of being attacked by malicious users against opened socket and enhance switch
security, the S3100 series Ethernet switches provide the following functions, so that a cluster socket is
opened only when it is needed:
Opening UDP port 40000 (used for cluster) only when the cluster function is implemented,
Closing UDP port 40000 at the same time when the cluster function is closed.
On the management device, the preceding functions are implemented as follows:
When you create a cluster by using the build or auto-build command, UDP port 40000 is opened
at the same time.
When you remove a cluster by using the undo build or undo cluster enable command, UDP port
40000 is closed at the same time.
Enabling NDP globally and on specific ports
Follow these steps to enable NDP globally and on specific ports:
Enter system view
Enable NDP globally
Enable
In system view
NDP on
Configuration task
Task
Operation Command
system-view
ndp enable
ndp enable interface
port-list
2-9
Remarks
Optional
Remarks
Required
Optional
Required
Optional
Required
Required
Optional
Description
—
Required
By default, NDP is
enabled globally.
Use either approach.
By default, NDP is