Jitter Test - H3C S3100 Series Operation Manual

DNS Resolve Time: 0
DNS Resolve Min Time: 0
DNS Resolve Max Time: 0
DNS Resolve Failed Times: 0
DNS Resolve Timeout Times: 0
TCP Connect Time: 73
TCP Connect Min Time: 5
TCP Connect Max Time: 20
TCP Connect Timeout Times: 0
[Sysname-hwping-administrator-http] display hwping history administrator http
HWPing entry(admin administrator, tag http) history record:
Index Response
1
2
3
4
5
6
7
8
9
10
For detailed output description, see the corresponding command manual.
When you use H3C S3100 Series Switches as HWPing Client for http test, if configuring the destination
address as the host name, you must configure the IP address of the DNS server to resolve the host
name into an IP address, which is the destination IP address of this HTTP test.

Jitter Test

Network requirements
Both the HWPing client and the HWPing server are H3C S3100 series Ethernet switches. Perform an
HWPing jitter test between the two switches to test the delay jitter of the UDP packets exchanged
between this end (HWPing client) and the specified destination end (HWPing server), with the port
number set to 9000.
Network diagram
Figure 1-6 Network diagram for the Jitter test
Configuration procedure
Configure HWPing Server (Switch B):
# Enable the HWPing server and configure the IP address and port to listen on.
Status LastRC
13 1
9 1
3 1
3 1
3 1
2 1
3 1
3 1
2 1
2 1
1-26
HTTP Operation Time: 675
HTTP Test Total Time: 748
HTTP Transmission Successful Times: 10
HTTP Transmission Failed Times: 0
HTTP Transmission Timeout Times: 0
HTTP Operation Min Time: 27
HTTP Operation Max Time: 80
Time
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.5
0 2000-04-02 15:15:52.4
0 2000-04-02 15:15:52.4
0 2000-04-02 15:15:52.4
0 2000-04-02 15:15:52.4
0 2000-04-02 15:15:52.4