H3C S3100 Series Operation Manual page 875

To do...
Configure the retaining time of
statistics information
Configure test start time and
lifetime
Enable routing table bypass
Configure the TTL
Configure the automatic test
interval
Configure the probe timeout time
Configure the type of service (ToS)
Start the test
Display test results
For an HWPing ICMP test, if no IP address is configured for the source interface configured
through the source-interface command, the test cannot be performed; if a source IP address has
already been configured through the source-ip command, the source-interface command does
not take effect.
In an ICMP test, after you specify a source interface by the source-interface interface-type
interface-number command, the TTL value turns to 1 automatically to test the directly connected
devices.
2) Configuring DHCP test on HWPing client
Follow these steps to configure DHCP test on HWPing client:
To do...
Enter system view
Enable the HWPing client
function
Use the command...
statistics keep-time keep-time
test-time begin { hh:mm :ss
[ yyyy/mm/dd ] | now } lifetime
lifetime
sendpacket passroute
ttl number
frequency interval
timeout time
tos value
test-enable
display hwping results
[ admin-name operation-tag ]
Use the command...
system-view
hwping-agent enable
1-6
Remarks
Optional
By default, the retaining time of
statistics information is 120
minutes.
Optional
By default,no test start time and
lifetime is configured.
Optional
By default, routing table bypass is
disabled.
Optional
By default, TTL is 20.
The sendpacket passroute
command voids the ttl command.
Optional
By default, the automatic test
interval is zero seconds, indicating
no automatic test will be made.
Optional
By default, a probe times out in
three seconds.
Optional
By default, the service type is zero.
Required
Required
Available in any view.
Remarks
—
Required
By default, the HWPing client function is
disabled.