Implementation Of Vlan-Vpn; Configuring The Tpid For Vlan-Vpn Packets - H3C S3100 Series Operation Manual

H3c s3100 series ethernet switches operation manual
Hide thumbs Also See for S3100 Series:
Table of Contents

Advertisement

Implementation of VLAN-VPN

With the VLAN-VPN feature enabled, no matter whether or not a received packet already carries a
VLAN tag, the switch will tag the received packet with the default VLAN tag of the receiving port and add
the source MAC address to the MAC address table of the default VLAN. When a packet reaches a
VLAN-VPN-enabled port:
If the packet already carries a VLAN tag, the packet becomes a dual-tagged packet.
Otherwise, the packet becomes a packet carrying the default VLAN tag of the port.

Configuring the TPID for VLAN-VPN Packets

The contents of this section are only applicable to the S3100-EI series among S3100 series switches.
A VLAN tag uses the tag protocol identifier (TPID) field to identify the protocol type of the tag. The value
of this field is 0x8100 for IEEE 802.1Q.
Figure 1-3
illustrates the structure of the IEEE 802.1Q VLAN tag in an Ethernet frame.
Figure 1-3 The structure of the VLAN tag in an Ethernet frame
0
An S3100 switch determines whether a received frame is VLAN tagged by comparing its own TPID with
the TPID field in the received frame. If they match, the frame is considered as a VLAN tagged frame. If
not, the switch tags the frame with the default VLAN tag of the receiving port.
By default, S3100 series switches adopt the IEEE 802.1Q TPID value 0x8100. Some vendors, however,
use other TPID values such as 0x9100. For compatibility with these systems, the S3100 series switches
allow you to change the TPID that a port uses when tagging a received VLAN-VPN frame as needed.
When doing that, you should set the same TPID on both the customer-side port and the service
provider-side port.
The TPID in an Ethernet frame has the same position with the protocol type field in a frame without a
VLAN tag. To avoid problems in packet forwarding and handling, you cannot set the TPID value to any
of the values in the table below.
Table 1-1 Commonly used protocol type values in Ethernet frames
ARP
IP
MPLS
IPX
15
TPID
Protocol type
Priority
VLAN ID
CFI
0x0806
0x0800
0x8847/0x8848
0x8137
1-2
31
Value

Advertisement

Chapters

Table of Contents
loading

Table of Contents