H3C S3100 Series Operation Manual page 789

The system supports ten channels. The channels 0 through 5 have their default channel names and are
associated with six output directions by default. Both the channel names and the associations between
the channels and output directions can be changed through commands.
Table 1-2 Information channels and output directions
Information channel
number
0
1
2
3
4
5
6
7
8
9
Configurations for the six output directions function independently and take effect only after the
information center is enabled.
Outputting system information by source module
The system information can be classified by source module and then filtered. Some module names and
description are shown in
Table 1-3 Source module name list
Module name
8021X
ACL
ADBM
AM
ARP
CMD
Default channel
name
console
monitor
loghost
trapbuffer
logbuffer
snmpagent
channel6
channel7
channel8
channel9
Table 1-3.
802.1x module
Access control list module
Address base module
Access management module
Address resolution protocol module
Command line module
1-2
Default output direction
Console (Receives log, trap and debugging information)
Monitor terminal (Receives log, trap and debugging
information, facilitating remote maintenance)
Log host (Receives log, trap and debugging information
and information will be stored in files for future retrieval.)
Trap buffer (Receives trap information, a buffer inside the
device for recording information.)
Log buffer (Receives log information, a buffer inside the
device for recording information.)
SNMP NMS (Receives trap information)
Not specified (Receives log, trap, and debugging
information)
Not specified (Receives log, trap, and debugging
information)
Not specified (Receives log, trap, and debugging
information)
Not specified (Receives log, trap, and debugging
information)
Description