This function is only applicable to ports that are in DLDP down state.
Follow these steps to reset DLDP state:
To do ...
Reset DLDP state for all the
ports shut down by DLDP
Reset the DLDP state for a port
shut down by DLDP
Displaying and Maintaining DLDP
To do ...
Display the DLDP configuration
of a unit or a port
DLDP Configuration Example
Network requirements
As shown in
Figure
Switch A and Switch B are connected through two pairs of fibers. Both of them support DLDP. All
the ports involved operate in mandatory full duplex mode, with their rates all being 1,000 Mbps.
Suppose the fibers between Switch A and Switch B are cross-connected. DLDP disconnects the
unidirectional links after detecting them.
After the fibers are connected correctly, the ports shut down by DLDP are restored.
Use the command ...
system-view
dldp reset
interface interface-type
interface-number
dldp reset
Use the command ...
display dldp { unit-id |
interface-type interface-number }
1-4,
1-11
Remarks
Select either of the two.
Remarks
Available in any view.