Monitor Link Configuration Example; Implementing Collaboration Between Smart Link And Monitor Link - H3C S3100 Series Operation Manual

H3c s3100 series ethernet switches operation manual

Hide thumbs Also See for S3100 Series:

Table of Contents

Table 2-5 Display Monitor Link configuration

Display the information about

one or all Monitor Link groups

Monitor Link Configuration Example

Network requirements

Link and Monitor Link to prevent the PCs from failing to access the server and Internet due to uplink link

or port failure.

Network diagram

Figure 2-3 Network diagram for Monitor Link configuration

Configuration procedure

Enable Smart Link on Switch A and Switch B to implement link redundancy backup. Perform the

following configuration on Switch A. The configuration on Switch B is the same as on Switch A.

# Enter system view.

<switchA> system-view

# Enter Ethernet port view. Disable STP on Ethernet1/0/1 and Ethernet1/0/2.

[SwitchA] interface Ethernet 1/0/1

display monitor-link group

{ group-id | all }

2-3, the PCs access the server and Internet through the switch. Configure Smart

You can use the display

command in any view.

Table of Contents