H3C S3100 Series Operation Manual page 708

# Enter system view.
<DeviceB> system-view
# Set Device C as the peer of Device B.
[DeviceB] ntp-service unicast-peer 3.0.1.33
Device C and Device B are symmetric peers after the above configuration. Device B works in symmetric
active mode, while Device C works in symmetric passive mode. Because the stratum level of the local
clock of Device B is 1, and that of Device C is 3, the clock of Device C is synchronized to that of Device
B.
View the status of Device C after the clock synchronization.
[DeviceC] display ntp-service status
Clock status: synchronized
Clock stratum: 2
Reference clock ID: 3.0.1.32
Nominal frequency: 100.0000 Hz
Actual frequency: 100.0000 Hz
Clock precision: 2^18
Clock offset: 0.66 ms
Root delay: 27.47 ms
Root dispersion: 208.39 ms
Peer dispersion: 9.63 ms
Reference time: 17:03:32.022 UTC Apr 2 2007 (BF422AE4.05AEA86C)
The output information indicates that the clock of Device C is synchronized to that of Device B and the
stratum level of its local clock is 2, one level lower than Device B.
# View the information about the NTP sessions of Device C (you can see that a connection is
established between Device C and Device B).
[DeviceC] display ntp-service sessions
source
*************************************************************************
[1234]3.0.1.32
[25]3.0.1.31
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations :
Configuring NTP Broadcast Mode
Network requirements
The local clock of Device C is set as the NTP master clock, with a stratum level of 2. Configure
Device C to work in the NTP broadcast server mode and send NTP broadcast messages through
Vlan-interface2.
Device A and Device D are two S3100 Ethernet switches. Configure Device A and Device D to
work in the NTP broadcast client mode and listen to broadcast messages through their own
Vlan-interface2.
reference
LOCL
127.127.1.0
2
stra reach poll now offset
1 95 64 42
2 1 64 1 4408.6
1-17
delay disper
-14.3 12.9 2.7
38.7 0.0