H3C S3100 Series Operation Manual page 335

Figure 3-7 Network diagram for MLD snooping proxying configuration
Source
Eth1/0/2
1::2/64
Router A
1::1/64
MLD querier
Configuration procedure
1) Configure IPv6 addresses for interfaces
Configure an IP address and prefix length for each interface as per
are out the scope of this document.
2) Configure Router A
# Enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable MLD on port
Ethernet 1/0/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface ethernet 1/0/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] pim ipv6 dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/0/2
[RouterA-Ethernet1/2] pim ipv6 dm
[RouterA-Ethernet1/2] quit
3) Configure Switch A
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign ports Ethernet 1/0/1 through Ethernet 1/0/4 to this VLAN, and enable MLD
snooping and MLD snooping proxying in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ethernet 1/0/1 to ethernet 1/0/4
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] mld-snooping proxying enable
[SwitchA-vlan100] quit
4) Verify the configuration
Receiver
Eth1/0/1
2001::1/64 Eth1/0/1
Switch A
Proxy & Querier
3-28
Host A
Receiver
Eth1/0/4
Eth1/0/3
Host B
Eth1/0/2
Host C
Figure 3-7. The configuration steps