MIPs are generated on each port automatically according to related MIP generation rules. If a port has
no MIP, the system will check the MAs in each MD (from low to high levels), and follow the procedure
described in
Figure 1-5
Figure 1-5 Procedure of creating MIPs
You can choose appropriate MIP generation rules based on your network design.
Follow these steps to configure the rules for generating MIPs:
To do...
Enter system view
Configure the rules for generating
MIPs
Any of the following actions or cases can cause MIPs to be created or deleted after you have configured
the cfd mip-rule command:
Enabling CFD (use the cfd enable command)
Creating or deleting the MEPs on a port
Changes occur to the VLAN attribute of a port
The rule specified in the cfd mip-rule command changes
to create or not to create MIPs (within a single VLAN):
Use the command...
system-view
cfd mip-rule { explicit | default }
service-instance instance-id
1-8
Remarks
—
Required
By default, neither MIPs nor the
rules for generating MIPs are
configured.