Ipv6 Configuration Task List; Configuring An Ipv6 Unicast Address - H3C S3100 Series Operation Manual

RFC 1981: Path MTU Discovery for IP version 6
RFC 2375: IPv6 Multicast Address Assignments
RFC 2460: Internet Protocol, Version 6 (IPv6) Specification.
RFC 2461: Neighbor Discovery for IP Version 6 (IPv6)
RFC 2462: IPv6 Stateless Address Autoconfiguration
RFC 2463: Internet Control Message Protocol (ICMPv6) for the Internet Protocol Version 6 (IPv6)
Specification
RFC 2464: Transmission of IPv6 Packets over Ethernet Networks
RFC 2526: Reserved IPv6 Subnet Anycast Addresses
RFC 3307: Allocation Guidelines for IPv6 Multicast Addresses
RFC 3513: Internet Protocol Version 6 (IPv6) Addressing Architecture
RFC 3596: DNS Extensions to Support IP Version 6

IPv6 Configuration Task List

Table 1-4 Complete these tasks to configure IPv6:

Configuring an IPv6 Unicast Address

Configuring IPv6 NDP
Configuring a Static IPv6 Route
Configuring IPv6 TCP Properties
Configuring the Maximum Number of IPv6 ICMP Error Packets Sent within a Specified
Time
Configuring the Hop Limit of ICMPv6 Reply Packets
Configuring ND Snooping
Configuring the ND Detection
Configuring DHCPv6 Snooping
Configuring IPv6 Filtering
Configuring IPv6 DNS
Displaying and Maintaining IPv6
Configuring an IPv6 Unicast Address
An IPv6 address is required for a host to access an IPv6 network. A host can be assigned a global
unicast address, a site-local address, or a link-local address.
To enable a host to access a public IPv6 network, you need to assign an IPv6 global unicast
address to it.
IPv6 site-local addresses and global unicast addresses can be configured in either of the following
ways:
EUI-64 format: When the EUI-64 format is adopted to form IPv6 addresses, the IPv6 address prefix
of an interface is the configured prefix and the interface identifier is derived from the link-layer
address of the interface.
Task
1-13
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional