H3C S3100 Series Operation Manual page 444

Operation
Display information about user
connections
Display information about local
users
Table 2-33 Display and maintain RADIUS protocol information
Operation
Display RADIUS message
statistics about local RADIUS
authentication server
Display configuration
information about one specific
or all RADIUS schemes
Display RADIUS message
statistics
Display buffered non-response
stop-accounting requests
Delete buffered non-response
stop-accounting requests
Clear RADIUS message
statistics
Table 2-34 Display and maintain HWTACACS protocol information
Operation
Display the configuration or
statistic information about one
specific or all HWTACACS
schemes
Display buffered non-response
stop-accounting requests
Clear HWTACACS message
statistics
Command
display connection [ access-type { dot1x |
mac-authentication } | domain isp-name |
interface interface-type interface-number | ip
ip-address | ipv6 ipv6-address | mac
mac-address | radius-scheme
radius-scheme-name | hwtacacs-scheme
hwtacacs-scheme-name | vlan vlan-id |
ucibindex ucib-index | user-name user-name ]
display local-user [ domain isp-name | idle-cut
{ disable | enable } | vlan vlan-id | service-type
{ ftp | lan-access | ssh | telnet | terminal } |
state { active | block } | user-name user-name ]
Command
display local-server statistics
display radius scheme
[ radius-scheme-name ]
display radius statistics
display stop-accounting-buffer
{ radius-scheme radius-scheme-name |
session-id session-id | time-range
start-time stop-time | user-name
user-name }
reset stop-accounting-buffer
{ radius-scheme radius-scheme-name |
session-id session-id | time-range
start-time stop-time | user-name
user-name }
reset radius statistics
Command
display hwtacacs
[ hwtacacs-scheme-name
[ statistics ] ]
display stop-accounting-buffer
hwtacacs-scheme
hwtacacs-scheme-name
reset hwtacacs statistics
{ accounting | authentication |
authorization | all }
2-30
Remarks
command in
any view.
Remarks
You can execute
the display
command in any
view.
You can execute
the reset
command in user
view.
Remarks
You can execute the
display command in
any view.
You can execute the
reset command in user
view.