Dhcp Test - H3C S3100 Series Operation Manual

Destination ip address:10.2.2.2
Send operation times: 10
Min/Max/Average Round Trip Time: 3/6/3
Square-Sum of Round Trip Time: 145
Last succeeded test time: 2000-4-2 20:55:12.3
Extend result:
SD Maximal delay: 0
Packet lost in test: 0%
Disconnect operation number: 0
System busy operation number: 0
Operation sequence errors: 0
Other operation errors: 0
[Sysname-hwping-administrator-icmp] display hwping history administrator icmp
HWPing entry(admin administrator, tag icmp) history record:
Index
1
2
3
4
5
For detailed output description, see the corresponding command manual.

DHCP Test

Network requirements
The HWPing client is an H3C S3100 series Ethernet switch, while the DHCP server can be an H3C
S5600 series Ethernet switch. Perform an HWPing DHCP test between the two switches to test the time
required for the HWPing client to obtain an IP address from the DHCP server.
Network diagram
Figure 1-3 Network diagram for the DHCP test
Configuration procedure
Configure DHCP Server(Switch B):
Configure DHCP server on Switch B. For specific configuration of DHCP server, refer to the DHCP
module in the H3C S5600 Series Ethernet Switches Operation Manual.
Configure HWPing Client (Switch A):
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
# Create an HWPing test group, setting the administrator name to administrator and test tag to DHCP.
[Sysname] hwping administrator dhcp
# Configure the test type as dhcp.
[Sysname-hwping-administrator-dhcp] test-type dhcp
# Configure the source interface, which must be a VLAN interface. Make sure the DHCP server resides
on the network connected to this interface.
Response Status
3 1
4 1
4 1
3 1
3 1
Receive response times: 10
DS Maximal delay: 0
Operation timeout number: 0
Connection fail number: 0
Drop operation number: 0
LastRC Time
0 2000-04-02 20:55:12.3
0 2000-04-02 20:55:12.3
0 2000-04-02 20:55:12.2
0 2000-04-02 20:55:12.2
0 2000-04-02 20:55:12.2
1-21