Configuring Basic Ethernet Oam Functions; Configuring The Ethernet Oam Connection Detection Timers - H3C S3100 Series Operation Manual

Configuring
Link Monitoring
Enabling OAM Remote Loopback

Configuring Basic Ethernet OAM Functions

As for Ethernet OAM connection establishment, a device can operate in active mode or passive mode.
After Ethernet OAM is enabled on an Ethernet port, according to its Ethernet OAM mode, the Ethernet
port establishes an Ethernet OAM connection with its peer port.
Follow these steps to configure basic Ethernet OAM functions:
To do...
Enter system view
Enter Ethernet port view
Set Ethernet OAM operating mode
Enable Ethernet OAM on the
current port
To change the Ethernet OAM operating mode on an Ethernet OAM-enabled port, you need to first
disable Ethernet OAM on the port.

Configuring the Ethernet OAM Connection Detection Timers

After an Ethernet OAM connection is established, the Ethernet OAM entities on both sides exchange
Information OAMPDUs at a specified interval (called the handshake packet transmission interval) to
check whether the Ethernet OAM connection is normal. If an Ethernet OAM entity receives no
Information OAMPDU within the Ethernet OAM connection timeout time, the Ethernet OAM connection
is considered disconnected.
By adjusting the handshake packet transmission interval and the connection timeout timer, you can
change the detection time resolution for Ethernet OAM connections.
Follow these steps to configure the Ethernet OAM connection detection timers:
Task
Configuring Errored Symbol Event Detection
Configuring Errored Frame Event Detection
Configuring Errored Frame Period Event Detection
Configuring Errored Frame Seconds Event Detection
System-view
interface interface-type
interface-number
oam mode { active | passive }
oam enable
Use the command...
1-6
Remarks
Optional
Optional
Optional
Optional
Optional
Remarks
—
—
Optional
The default is active Ethernet OAM
mode.
Required
Ethernet OAM is disabled by
default.