Operation
Display the stack status
information on a slave switch
Stack Configuration Example
Network requirements
Connect Switch A, Switch B and Switch C with each other through their stack ports to form a stack,
in which Switch A acts as the main switch, while Switch B and Switch C act as slave switches.
Configure Switches B and Switch C through Switch A.
Network diagram
Figure 1-1 Network diagram for stack configuration
Configuration procedure
# Configure the IP address pool for the stack on Switch A.
<Sysname> system-view
[Sysname] stacking ip-pool 129.10.1.15 3
# Create the stack on switch A.
[Sysname] stacking enable
[stack_0.Sysname] quit
<stack_0.Sysname>
# Display the information about the stack on switch A.
<stack_0.Sysname> display stacking
Command
display stacking
1-5
Description
The display command can be
executed in any view.
The displayed information
indicates that the local switch is
a slave switch. The information
such as stack number of the
local switch, and the MAC
address of the main switch in
the stack is also displayed.