H3C S3100 Series Operation Manual page 985

Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [Ethernet1/0/1]:
Port status of LLDP
Admin status
Trap flag
Roll time
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV
Port 2 [Ethernet1/0/2]:
Port status of LLDP
Admin status
Trap flag
Roll time
Number of neighbors
Number of MED neighbors
Number of CDP neighbors
Number of sent optional TLV
Number of received unknown TLV
As the sample output shows, Ethernet 1/0/1 of Switch A connects a MED device, and Ethernet 1/0/2 of
Switch A connects a non-MED device. Both ports operate in Rx mode, that is, they only receive LLDP
frames.
# Tear down the link between Switch A and Switch B and then display the global LLDP status and port
LLDP status on Switch A.
[SwitchA] display lldp status
Global status of LLDP : Enable
The current number of LLDP neighbors : 1
The current number of CDP neighbors : 0
LLDP neighbor information last changed time: 0 days,0 hours,5 minutes,20 seconds
Transmit interval
Hold multiplier
Reinit delay
Transmit delay
Trap interval
Fast start times
Port 1 [Ethernet1/0/1]:
: 4
: 2s
: 2s
: 5s
: 3
: Enable
: Rx_Only
: No
: 0s
: 1
: 1
: 0
: 0
: 0
: Enable
: Rx_Only
: No
: 0s
: 1
: 0
: 0
: 0
: 3
: 30s
: 4
: 2s
: 2s
: 5s
: 3
1-14