Table of Contents
Advertisement
Line #1:
L:LCD16
Selection Options
Select Destination Mode
JUPITER L-S and LCD Series Control Panel Instruction Manual175
2. Press the
Protect/Lock
button will then turn a solid red.
3. Press the
button in the Command buttons section. The
Take
Destination's button color will then change to red and the
button will blink red.
Note
If the Sticky Destination feature has been turned on for the panel, the button
will be white. Press the selected button again to change the color.
The letter "L" will appear in front of the name of the panel that pro-
tected the Destination. See
Figure 94. Locked Destination Displayed
L:LCD16
PINP-004
OUT-255
You may have access to numerous Destinations or outputs. The Select Des-
tination mode was designed to quickly find a specific Destination. The
Select Destination mode can be accessed from the main menu's "select des-
tination?" button. The Select Destination mode is also available for use in
the following modes: XY-Mode, Multi-Destination mode, Single-Destina-
tion mode, and Level mode.
Note
The Select Destination mode is not available in the Category entry and the
B.P.S. modes.
There are two methods of selecting a Destination, Direct Entry and Cate-
gory Entry. Each of these methods will be explained below. Both of these
Instruction steps assume the
pressed. The LCD16 is different from the LCD48 because the LCD48 dis-
plays both the Direct Entry (on the Left half) and the Category Entry (on the
Right half) of the panel. The LCD16 requires the use of
button to switch between the direct entry and category entry modes.
button in the Command buttons section twice. The
Figure 94
for an example.
button in the Level mode has been
Destination
Basic Panel Operations
Protect/Lock
Select Destination
Advertisement
Table of Contents
