9G-3 Seats:
Front Seat Removal and Installation
Removal
1) Disable air bag system referring to "Disabling Air
Bag System in Section 8B".
2) Disconnect seat harness coupler and side air bag
coupler, if equipped.
3) Remove 4 mounting bolts to remove seat assembly.
4) Disassemble and repair seat as necessary.
Installation
Reverse removal procedure to install front seat.
• Torque to specifications as shown in "Front Seat
Components".
• Enable air bag system referring to "Enabling Air Bag
System in Section 8B".
Front Seat Heater Switch (Driver and Passenger
Side) Inspection (If Equipped)
1) Confirm that ignition switch is OFF position.
2) Remove console box.
3) Disconnect seat heater switch coupler and remove
seat heater switch.
4) Check for continuity between terminals at each
switch position as shown below. If check result is not
as specified, replace.
Front Seat Heater Wire Inspection (If Equipped)
S6RW0D9706002
1) Confirm that seat heater switch is OFF position.
2) Disconnect coupler of seat heater under the seat
cushion.
3) Measure resistance between terminals as shown
below. If resistance is out of specification, replace
faulty seat cushion and/or seat back including seat
heater.
Seat heater circuit resistance
Seat cushion side [A] (between terminal "B" and
"C", between terminal "A" and "C"): 4.7 – 5.7 Ω
(at 20 °C, 68 °F)
Seat back side [B] (between terminal "F" and
"D": 10.7 – 13.1 Ω (at 20 °C, 68 °F)
S6RW0D9706005
I5RW0B970001-02
[A]
[B]
A
B
C
1
2
1
1. Heater wire
[A]: Seat cushion side
2. Thermostat
[B]: Seat back side
S6RW0D9706006
D E
F
I5JB0A970002-01