Konica Minolta bizhub PRO C5500 Solution Manual page 22

bizhub PRO C5500
Solution ID TAUS0702464EN*
Description
Jitter in the sub scan direction on thick paper only.
Solution
CAUSE: The stiffness of the paper is causing it to flex during transfer.
SOLUTION: Set the 2nd paper transfer setting to low. To Set the 2nd paper transfer setting to low, perform he following:
1. From theMACHINE screen, select [Paper Setting].
2. Select [Change].
3. Select [Process Adjustment].
4. Select [Next] 2 times.
5. Select [Low].
6. Exit the Paper Setting mode.
Note : If Process Adjust is not displayed in the Paper Setting mode, set software DipSwitch 1-0 = 1.
SPECIAL NOTE : Solution contribution by Jim Behrends and Chuck Tripp, Production Print/SSD
Solution ID TAUS0808059EN*
Description
Blurred colored text. Toner scattered around color text as if the characters are blurred.
Solution
CAUSE: More toner is laid down on multiple color text than single color text. With the thick toner later, discharge may occur during image transfer causing
toner scattering to occur.
SOLUTION: Reduce toner quantity of the color of the blurred text. To reduce the toner quantity, perform the following:
1.Press the Utility/Counter button.
2.Select Machine Admin Setting.
3.Select System Setting.
4.Select Expert Setting.
5.Select Process Adjustment.
6.Select Toner Quantity/Exposure.
7.Decrease the Maximum Toner Quantity value for the desired color(s).
8.Exit Machine Admin mode.
Note : After adjusting the Maximum Toner quantity setting, perform the controller calibration.
SPECIAL NOTE : Solution contribution by Ed Bellone, Production Print/SSD
TAUS0808065EN*
Solution ID
Description
Blurred text on the trail edge on gloss paper.
Solution
CAUSE: Machine speed is too fast for gloss type paper.
SOLUTION: Slow the machine speed for the paper in the Paper Settings. To change the machine speed, perform the following:
1.Press tab on the operation panel.
2.Select Paper Setting.
3.Select the paper tray that the gloss paper is loaded in.
4.Select Change.
5.Select Process Adjust.
Note : If the Process Adjust tab is not present, turn soft switch 1-0 = 1 (ON).
6.Select Next.
7.Select Next.
8.Set Speed Down to ON Set CPM Down to Down.
9.Exit Paper Setting mode.
SPECIAL NOTE : Solution contribution by Ed Bellone, Production Print/SSD
Solution ID TAUS0702194EN*
Description
When copying or printing, the printed image is 1mm or 2mm shorter than the original.
Copyright , Konica Minolta Business Solutions U.S.A., Inc.
Image failure other than density/color - magnification, blur
22
Solution Usage 8
Solution Usage 2
1
Solution Usage
Solution Usage 0
March 2010