Konica Minolta bizhub PRO C5500 Solution Manual page 105

bizhub PRO C5500
SPECIAL NOTE : Solution contribution by Ian Lynch and David Aekus, Production Print/SSD
Solution ID TAUS0800303EN*
Description
FS-607, Vertical Position Punch Adjustment does not work.
Solution
CAUSE: The Paper Edge Detect Sensor Punch Adjustment has not been performed.
SOLUTION: Perform the Paper Edge Detect Sensor Punch Adjustment prior to performing the Vertical Position Punch Adjustment, follow these procedures:
1. Enter Service Mode.
2. Select Finisher Adjustment.
3. Select Punch Adjustment.
4. Select Paper Edge Detect SensorAdjustment.
5. Select START.
6. When completed then perform the Vertical PositionAdjustment again.
SPECIAL NOTE : Solution contribution by Gregg Gallant and Ed Bellone, Production Print/SSD
Solution ID TAUS0800975EN*
Description
J-3201.
Solution
PROBABLE CAUSES:
1.Too much toner on page when printing with high toner coverage. There is a very high toner coveragewith the papersometimes wrapping around the fuser
roller and sticking thus causing the jam.
In the printer driver, select TONER REDUCTION which islocated under the IMAGE tab.
2. Damaged linkage for paper exit gate or failed paper exit solenoid SD4. The jam occurs when duplexing either face up or face down. Paper stops in the
inversion section at reverse roller/Lw before entering the ADU section. All motors and sensors test good in state confirmation mode.
Test SD4 in state confirmation mode 80-0. Repair linkage (p/n 65AA 4928 0) or replace SD4 (p/n 65AA R704 00) if deemed necessary.
3. Broken Locking Cam.
Replace Locking Cam (p/n 65AA 5032 0).
Note : See attached document as a reference. To viewthe PDF, Adobe Reader® must be installed. Adobe Reader® can be downloaded for free from the
Adobe® web site at: http://www.adobe.com/products/acrobat/readstep2.html .
SPECIAL NOTE : Solution contribution by Mike McCarthy and Ed Bellone, Production Print/SSD
TAUS0801224EN*
Solution ID
Description
J-1705 (J1705) or J-1706 (J1706) when paper is fed from Tray 2 or Tray 3 respectively. Possibly J-1706 will occur ONLY when feeding from Tray 1.
Solution
PROBABLE CAUSES:
1.Intermediate conveyance clutch MC13 has 24V DC continuously. PRCB ICP27 is not OPEN. The PRCB has failed.
Replace the PRCB (p/n A03U R759 00).
2. Conveyance clutch 1 (MC13) has no power.
Check ICP28 on the PRCB to determine if it is OPEN.Check the wiring to the clutchfor a short to ground.Replace the PRCB (p/n A03U R759 00) if necessary.
3. Damaged Tray 1 connector (cassette signal wire).
Note : J-1706 when feeding from Tray 1.
To locate the problem:
Check MC8 (pre-registration clutch)in I/O mode, 22-0.
Check for 24V DC at PRCB, CN400-4A.
Check for paper behind Tray 1.
Copyright , Konica Minolta Business Solutions U.S.A., Inc.
Paper Conveyance jams, no-feed, folding, tearing, skewing, curling
105
Solution Usage 3
Solution Usage 3
3
Solution Usage
March 2010