SOLUTION: Ensure that a specific paper feed tray is not selected in the print driver. To use ATS, the paper tray setting in the print driver needs to be set to

Automatic.

Note : Ensure that the ATS settings in user mode are enabled. To enable ATS settings perform the following:

1. Press the Utility key.

2. Select User Setting.

3. Select System Setting.

4. Select Feed Tray Setting.

5. Select ATS Permit.

6. Select ON.

7. Select OK.

8. Select Feed Tray Auto Select.

9. Select the desired feed trays to be included in the ATS search.

10. Set the tray priority for the ATS search.

11. Select OK.

12. Select Auto Paper Type.

13. Select paper types, weights, hole-punch, tab, color papers to be included in ATS.

14. Select OK.

15. Exit User mode.

16.Select Paper Setting on the Machine Screen.

17.Select a tray in the ATS list.

18. Select Size Setting.

19.Select or confirm it is set to normal and select OK.

20. Perform same for other trays.

SPECIAL NOTE : Solution contribution by Ed Bellone, Production Print/SSD and Reginald Tingle, KMBS - Hawthorne

Solution ID

TAUS0800469EN*

Description

ISW error 196when attempting to flash firmware.

Solution

When booting theMFP, the control panel indicates aC-C113 (CC113) or C-C114 (CC114)

CAUSE: At the rear of the machine, DIPsw 2 is set to "OFF" or the jumper is inserted in CN19.

SOLUTION: Set DIPsw 2 to "ON" and remove jumper and reinstall connector into CN19. Note : The error relating to FD-501 is C-C113 and for SD-501,

C-C114. For the LS-501, make sure that the connector jack is disconnected and plugged into the connector plugs of the RU-503 unit. Please seesteps 8

& 9on pages E8/E9 of the attached LS-501 Installation Manual. To viewthe PDF, Adobe Reader® must be installed. Adobe Reader® can be downloaded

for free from the Adobe® web site at: http://www.adobe.com/products/acrobat/readstep2.html .

When flashing the PB-501/PB-502

CAUSE: The jumper for CN29 on the PBCB is connected.

SOLUTION: The jumper for CN29 on the PBCB must be removed and the wiring connector connected. The jumper is only used when the Perfect Binder is

installed on abizhub PRO1050.

After replacing PWB-PRCB

CAUSE: When the PWB-PRCB was installed CN301 was not connected.

SOLUTION: Unplug theMFP from the wall outlet and connect CN301. The connector is a 4-pin connector located on the bottom of PWB-PRCB.

SPECIAL NOTE : Solution contribution by Chuck Tripp/Freddie Burnham/Ed Bellone/Ian Lynch/Gary Scimeca, Production Print/SSD

Solution ID

TAUS0802287EN*

Description

C-4521 (C4521) color registration error code.

Solution

CAUSE: It is possible toner or dust is deposited between the color registration sensors, PS8 and PS9, and their outer cover. Simply wiping the sensor will not

Warm-up, wrong display, incorrect operation, lock-up

142

Solution Usage

March 2010