Konica Minolta bizhub PRO C5500 Solution Manual page 162

bizhub PRO C5500
Solution ID TAUS0703611EN*
Description
FS-520/FS-607, J-7229.
Solution
CAUSE: The main tray paper exit sensor PS6 (p/n 08AA85512) does not turn OFF within a specified period of time after it turns ON (while in the non-stapling
mode). The sub tray paper exit sensor PS1 (p/n 08AA85512) does not turn OFF within a specified period of time after it turns ON (while in the stapling mode).
SOLUTION: Remove jammed paper in the finisher/main body, if any. Manually check the operation of the sensors in the I/O State Confirmation mode. Look
for sticky or nicked actuators and replace as necessary.
SPECIAL NOTE : Solution contribution by Freddie Burnham, Production Print/SSD
TAUS0703691EN*
Solution ID
Description
Delete button is missing from the Program Overlay screen.
Solution
CAUSE: Change Image Overlay is set to "Prohibition".
SOLUTION: Set Change Image Overlay to "Permission" by performing the following:
1.Select the Utility/Counter button on the control panel.
2.Select [03 Machine Admin. Setting] on the touchscreen.
3.Select [01 System Setting] on the touchscreen.
4.Select [04 Operation Prohibit Set] on the touchscreen.
5.Select [02 Change Prohibit setting] on the touchscreen.
6.Select [Permission] for the Set Change Program Image Overlay setting.
SPECIAL NOTE : Solution contribution by Ian Lynch, Production Print/SSD
TAUS0703761EN*
Solution ID
Description
DF-609, J-6102.
Solution
CAUSE: Pick-up roller not returning to home position when ADF paper feed cover is closed because the magnetic reed switch (RS) for ADF position
detection has failed or is out of position.
SOLUTION: Replace or reposition the reed switch (p/n 65AA 8501 0).
SPECIAL NOTE : Solution contribution by Ian Lynch, Production Print/SSD
Solution ID TAUS0703812EN*
Description
FS-607, C-1104 (C1104) when outputting copies/prints to the main tray.
Solution
CAUSE: Broken drive coupling gear on rear of stacker unit.
SOLUTION: Replace drive coupling gear (p/n 129U77041).
SPECIAL NOTE : Solution contribution by Ed Bellone, Production Print/SSD
Solution ID TAUS0703866EN*
Description
J-7317 orJ-7314.
Solution
CAUSE: The corresponding paper entrance sensor/Up (PS201) or sensor/Lw (PS206) turns ON while machine in idle.
SOLUTION: Check sensor PS201 and/or PS206 in the State Confirmation Mode (47 mode) for proper operation and replace as necessary. Photosensor (p/n
08AA 8551 2), key 17 on page 4 of the PI-502 Parts Manual) and actuator (p/n 13QE 4807 0), key 19.
SPECIAL NOTE : Solution contribution by Freddie Burnham, Production Print/SSD
Copyright , Konica Minolta Business Solutions U.S.A., Inc.
Warm-up, wrong display, incorrect operation, lock-up
162
Solution Usage
Solution Usage
Solution Usage
Solution Usage
Solution Usage
March 2010