Konica Minolta bizhub PRO C5500 Solution Manual page 19

bizhub PRO C5500
Solution ID TAUS0700120EN*
Description
Varying second side registration in the main scan direction.
Solution
CAUSE: Failed ADU centering sensor (PS65).
SOLUTION: Replace ADU centering sensor (p/n 56UA85510E).
Note :Part number provided by Alexander Fedoseev - KMBS/Ft. Myers.Part number and sensor designationin the Service Manual are incorrectly
labeledcausing confusion when ordering.Part numbers in the Parts Manual are correct.
SPECIAL NOTE : Solution contribution by Jim Behrends, Production Print/SSD
TAUS0701183EN*
Solution ID
Description
Intermittent half-inch image shift on second side in the main scan direction.
Solution
PROBABLE CAUSES:
1. Failed Image Processing Board (IPB).
Verify failed Image Processing Board by swapping it with another board if possible. Replace the IPB as necessary (p/n A03U H020 28 for bizhub PRO
C6500/C5500 and p/n A0U0 H020 02 for bizhub PRO C6501/C5501 ).
2. Failed ADU centering sensor (PS65).
Replace the ADU centering sensor (p/n 56UA 8551 0E for bizhub PRO C6500/C5500 and p/n 56UA 8551 0E for bizhub PRO C6501/C5501 ).
SPECIAL NOTE : Solution contribution by Ian Lynch/Freddie Burnham/Mike McCarthy/Ed Bellone/Chuck Tripp, Production Print/SSD
Solution ID TAUS0703539EN*
Description
How to adjust the 1st side and 2nd side image registration.
Solution
Please refer the attached documentation if the customer requests accurate image registration between 1st side and 2nd side using PF-601 and LU-202. It
describes paper skew, trailing edge timing, centering error, vertical magnification and horizontal magnification adjustment procedure.
If the customer uses the PF-601 and LU-202, and requests accurate image registration between 1st side and 2nd side, please perform following:
1. PF-601 side guides fine adjustment (correct 1st side skew).
2. LU-202 side guides fine adjustment (correct 1st side skew).
3.Enable [Side 2 lens adjustment mode].
4. Image position adjustment -method to adjust the trailing edge, centering error, vertical zoom and horizontal zoom using the [Chart adjustment].
Note : To view the attached document, Microsoft® Excel® or Excel® Viewer must be installed. Excel® Viewer 2003 (9.9MB) can be obtained free from
Microsoft® at the following URL;
http://www.microsoft.com/downloads/details.aspx?FamilyID=c8378bf4-996c-4569-b547-75edbd03aaf0&displaylang=EN.SPECIAL .
SPECIAL NOTE : Solution contribution by Ed Bellone and Ian Lynch, Production Print/SSD
TAUS0701444EN*
Solution ID
Description
Image is skewed on the paper.
Solution
CAUSE: Registration loop adjustment has not been performed.
SOLUTION: Perform the Registration Loop Adjustment.
Follow these procedures:
Copyright , Konica Minolta Business Solutions U.S.A., Inc.
Image delay, advance, shift or skew
19
Solution Usage 17
17
Solution Usage
Solution Usage 12
4
Solution Usage
March 2010