1. The actuator for PS6 is hitting the paper exit guide plate when the paper exit section closes. This may cause PS6 not to be deactivated and register a jam.

Reform that the paper exit guide plated/lower assembly (p/n A04D A896 0) if it is bent in the center and interfering with the actuator for PS6. Replace the

paper exit guide plate/lower assembly if necessary.

2. The Curl Adjustment is set to Small.

Set the Curl Adjustment to Large or Middle by using the below procedure:

a. Enter Service Mode.

b. Select Finisher Adjustment.

c. Select Curl Adjustment.

d. Select Middle or Large.

e. Select OK.

3. An incorrect Finisher Adjustment setting.

Recall Standard Data for Finisher Adjustment using the below procedure:

a. Enter Service Mode.

b. Select Finisher Adjustment.

c. Select Recall Standard Data.

d. Select Factory Initial Data.

e. When "Recall Factory Initial Data" is displayed select Yes.

f. Select Return.

g. Select Close.

h. Select Exit.

i. Select Exit.

Note : The Finisher Adjustments will be returned to the factory values after recalling factory initial data is selected. Readjustment of the Finisher

Adjustments may be necessary.

SPECIAL NOTE : Solution contribution by Ian Lynch, Production Print/SSD andClinton Marquardt, ESS

Solution ID

TAUS0651354EN*

Description

FD-501, SC77-33 (3-hole) or SC77-34 (4-hole) after approximately 30,000 punch operations. The codes for the bizhub PRO 6500 MFPs are C-1224 or

C-1225.

Solution

CAUSE: Soilage, such as toner residue, is adhered to impregnated oil of the punch pin slide bearing which is attached to the punch pin (punch support

pedestal/A - p/n 13QR10100).

SOLUTION: Clean the punch pin and the punch support pedestal approximately every 100,000 punches. If the punch pin is damaged, replace the punch unit

(p/n 15AH-550 1).

Note : Use the procedure beginning on page 2 of attached Bulletin Number 6433 to clean the punch units listed in the included table. Punch units with

serial numbers greater than those listed were produced with a design that prevents binding.

TAUS0657171EN*

Solution ID

Description

On the PF-601 and LU-202, when approximately 2000 sheets of coated paper are fed under low temperature environment, a no feed jam or misfeedoccurs.

Solution

CAUSE: The resin from the coated paper is attached on the paper feed roller, the separation roller and the pick-up roller. The friction coefficient of the pick-up

roller surface decreases and causes the misfeed.

SOLUTION: Clean the paper feed roller, the separation roller and the pick-up roller. Install the countermeasure against no feed jam/misfeed of coated paper.

Please refer to the attached Bulletin Number 6198 regarding the new style paper feed mechanism for the PF-601 and Bulletin Number 6381 regarding the

new style paper feed mechanism for the LU-202. To view a PDF, Adobe Reader® must be installed. Adobe Reader® can be downloaded for free from the

Adobe® web site at: http://www.adobe.com/products/acrobat/readstep2.html .

Paper Conveyance jams, no-feed, folding, tearing, skewing, curling

104

Solution Usage

March 2010