If the message clears, set DiPSW 15-3and 15-4 to 1 . This allows the machine to continue printing even if an alarm stop signal is received (tray full, tray lower

limit, waste full, etc.) from the FD/FS/LS/SD. DIPSW 15-3 and 15-4 will need to be set back to 0 after the FNSCB is replaced.

SPECIAL NOTE : Solution contribution by Gregg Gallant and Chuck Tripp, Production Print/SSD

Solution ID

TAUS0700712EN*

Description

J17-02 only when duplexing.

Solution

CAUSE:ADU loop timingis incorrect.

SOLUTION:To adjust the ADU loop timing, perform the following:

1. Access service mode.

2. Touch Machine Adjustment.

3. Touch Printer Adjustment.

4. Touch Registration Loop Adjustment.

5. Touch the down arrow to second screen.

6. Select appropriate size and weight to adjust.

7. Increase loop values until the jamming is corrected.

SPECIAL NOTE : Solution contribution by David Aekus, Production Print/SSD

Solution ID

TAUS0800920EN*

Description

FS-503/FS-520/FS-607, J-7301.

Solution

CAUSE: The main tray exit sensor PS10 (FS-503 -p/n 08AA 8551 2) or PS6 (FS-520/FS-607 -p/n 08AA 8551 2) turns ON while in idling.

SOLUTION: Remove jammed paper in the finisher/main body, if any. Check the operation of the sensor PS10 in the I/O state confirmation mode, code 72-13

(FS-503) or for PS6, code 72-6 (FS-520/FS-607). Replace the sensor as necessary.

SPECIAL NOTE : Solution contribution by Freddie Burnham and Ed Bellone, Production Print/SSD

TAUS0808144EN*

Solution ID

Description

J-17xx codes when feeding from bypass; any paper size or weight.

Solution

CAUSE: Dirty or failed bypass feed clutch (MC8).

SOLUTION: Clean and/or replace bypass feed clutch (p/n 56AA 8201 2).

SPECIAL NOTE : Solution contribution by Mike McCarthy, Production Print/SSD

Solution ID

TAUS0808613EN*