Konica Minolta bizhub PRO C5500 Solution Manual page 154

bizhub PRO C5500
Test pattern (No. 16) is blank whenperforming Printer Adjustments.
Solution
CAUSE: The black density is improperly set in Test Pattern Output Mode.
SOLUTION: Set the black density by using the below procedure:
1.Access Service Mode.
2.Select [11 Test Mode] on the touchscreen.
3.Select [02 Test Pattern Output mode] on the touchscreen.
4.Select [Tone-K] on the touchscreen.
5.Enter 255 using the touchscreen or keypad.
6.Select [Set] on the touchscreen.
SPECIAL NOTE : Solution contribution by David Aekus, Production Print/SSD
Solution ID TAUS0801237EN*
Description
"Please close finisher door" message.
Solution
CAUSE: Wire harness shorted against drive shaft. FNSCB has failed.
Note : There is 24V DC present at the interlock.
SOLUTION: Replace wire harnessA (p/n 15AA90010) and FNSCB (p/n 15AA-9312F).
SPECIAL NOTE : Solution contribution by Mike McCarthy, Production Print/SSD
TAUS0801593EN*
Solution ID
Description
ERROR message when performing toner density sensor initial auto-adjustment.
Solution
CAUSE: Either the Toner Supply Unit is not set or the front door is open.
SOLUTION: Make certain that the Toner Supply Unit is set and the front door is closed.
SPECIAL NOTE : Solution contribution by Jim Behrends, Production Print/SSD
TAUS0801832EN*
Solution ID
Description
When FS-607 booklet tray is full, printing does not stop.
Solution
CAUSE: Firmware update required.
SOLUTION: Please update to firmware version 40 or greater. The latest version of firmware, system software or print drivers is available via the Konica
Minolta Download Selector. Access the Selector from SSD Web Support (CS Expert Support) by clicking on 'Download MSDS, Drivers, Firmware and more'.
Solution ID TAUS0802025EN*
Description
Intermittent C-0201 (C0201), C-0202 (C0202) and C-0203 (C0203)paper lift error codes.
Solution
PROBABLE CAUSES:
1.The trail edge paper guide (p/n A03U R756 00) may not be pressed against the paper. This will allow the paper to fall backwards and induce the error code.
Instruct the end user to check the position of the trail edge paper guide whenever paper is loaded into the paper tray.
2. Coupling for the tray lift for Tray 1, Tray 2 or Tray 3 is obstructed or out of alignment causing the tray to not lift.
Inspect the coupler in the back of the machine for paper preventing the pin from seating in the coupler. Check alignment when tray is inserted. If out of
alignment try to adjust the drive to properly align.
Copyright , Konica Minolta Business Solutions U.S.A., Inc.
Warm-up, wrong display, incorrect operation, lock-up
154
Solution Usage 1
1
Solution Usage
1
Solution Usage
Solution Usage 1
March 2010