Konica Minolta bizhub PRO C5500 Solution Manual page 152

bizhub PRO C5500
Description
Deformation of the reverse decurler roller causing noise and wrinkling of paper.
Solution
CAUSE: Deformation can occur when the reverse deculer roller is stationary for a long period of time.
SOLUTION: Set DIPSW 3-2 to1 to enable reverse decurler roller preliminary rotation. This will rotate the roller for 5 minutes after the end of print operation
and for a fixed period of time during image stabilization control.
SPECIAL NOTE : Solution contribution by Ian Lynch, Production Print/SSD
Solution ID TAUS0703590EN*
Description
Cannot select certain scan options; SMB, FTP, E-mail.
Solution
CAUSE: Certain scanning options have been set to Prohibit in Machine Admin mode.
SOLUTION: Follow this procedure to change this setting in Machine Admin mode:
1. Select Utility.
2. Select Machine Admin.
3. Select System Set.
4. Select Prohibit Set.
5. Select Scan Prohibit.
6. Set the desired scan options to Permission.
7. Select OK.
SPECIAL NOTE : Solution contribution by Gregg Gallant, Production Print/SSD
Solution ID TAUS0703813EN*
Description
J17-08.
Solution
CAUSE: Possibleopen 24V ICP9 fuse (fuse type ICP-S1.0) on the Conveyance Drive Board Assembly.
SOLUTION: Check foropen ICP fuse on the CVDB and replace the CVDB (p/n A03U H050 04)if necessary.
SPECIAL NOTE : Solution contribution by Freddie Burnham, Production Print/SSD
TAUS0703815EN*
Solution ID
Description
C2811 (C-2811) error codeat power up.
Solution
CAUSE: Failed PRCB.
SOLUTION: Replace the PRCB (p\n A03UR75900).
SPECIAL NOTE : Solution contribution by Gregg Gallant, Production Print/SSD
TAUS0800233EN*
Solution ID
Description
LU-202, intermittent J-1502 codes.
Solution
PROBABLE CAUSES:
1.Failed LU exit sensor (PS107).
Check the operation of (PS107) using I/O check mode by entering code 20 multi-code 0. he display should be 001 when paper is present and 000 when no
paper is present. Replace the LU exit sensor (p/n 56AA 8552 1) if it is not displaying the correct state.
2.Failed pre-registration clutch (MC102).
Check the operation of (MC102) using I/O check mode by entering code 22 multi-code 5. Replace the pre-registration clutch (p/n 56AA 8201 2) if it is not
being activated in I/O mode.
3.Loose or damaged connector between (PS107) and the LUDB.
Replace failed LUDB (p/n A03W H010 02).
Copyright , Konica Minolta Business Solutions U.S.A., Inc.
Warm-up, wrong display, incorrect operation, lock-up
152
Solution Usage 1
Solution Usage 1
1
Solution Usage
1
Solution Usage
March 2010