Samsung OfficeServ 7100 Technical Manual page 71

OfficeServ 7100
TECHNICAL MANUAL
MMC: 200
DESCRIPTION:
Used to open (enable) and close (disable) customer-level programming. If
programming is not opened and an attempt is made to access a system MMC, the
error message [NOT PERMIT] will be displayed. A four digit passcode is required to
access this MMC. Each digit can be 0-9. When opened, this MMC enables access to
all MMCs allowed in MMC 802 Customer Access MMC Number.
PROGRAM KEYS
UP & DOWN Select open or closed
KEYPAD Used to enter passcode
SPEAKER Save data and advance to next MMC
TRANSFER Exit Programming
ACTION
1. Press TRANSFER 200
Display shows
2. Enter passcode.
Correct code shows.
Incorrect code shows.
3. Press UP or DOWN arrow key to select
ENABLE or DISABLE and press RIGHT soft
key
OR
Dial 1 for ENABLE or 0 for DISABLE.
OPEN CUSTOMER PROGRAMMING
ENABLE CUS.PROG.
PASSCODE:
ENABLE CUS.PROG.
PASSCODE:
ENABLE CUS.PROG.
DISABLE
ENABLE CUS.PROG.
PASSWORD ERROR
ENABLE CUS.PROG.
ENABLE
Home Page
PROGRAMMING
PART 2 APRIL 2007
DISPLAY
Table of Contents