Samsung OfficeServ 7100 Technical Manual page 436

Hide thumbs Also See for OfficeServ 7100:

OfficeServ 7100

TECHNICAL MANUAL

DESCRIPTION:

This MMC permits the adjustments of optional Session Initiation Protocol (SIP)

trunking parameters. The MGI supports SIP and H.323 on a per call-per-port basis.

The settings are systemwide.

NOTE: When changing any IP address/value, listed below, three digits must

be input for each (octet) field. Example 192.168.1.10 input must be: 192 168

SIP Stack Configuration

• RE-TRANS T1:

• RE-TRANS T2:

• RE-TRANS T4:

• GENERAL RING:

• INVITE RING:

• PROVISIONAL:

• INV NO RESP:

The initial re-transmission time if no answer based on the

RFC2543 specification. Default 500 ms.

The maximum re-transmission time if no answer based on

the RFC2543 specification. Default 4000 ms.

The time the User Agent Server waits after receiving the ACK

message. Based on the RFC2543 specification. Default

5000ms. The range is 0~9900.

The server shall re-transmit the response during this amount

of time until the requested re-transmission is received. For

example, the wait time after sending 200 OK for INFO. The

range is 0~99900.

After the client sends ACK for the INVITE Final Response, the

client cannot confirm if the server received the ACK message.

The client waits for this amount of time after sending ACK for

the Final Response. The range is 0~99900.

After receiving the Provision Response, the User Agent shall

wait for this amount of time until Timeout ends. The range is

Before sending Cancel for the Invite Request, the User

Agent shall wait for this amount of time. The range is

PART 2 MAY 2009

Table of Contents