Samsung OfficeServ 7100 Technical Manual page 346

OfficeServ 7100
TECHNICAL MANUAL
MMC: 741
DESCRIPTION:
This MMC is used to determine if the embedded SVM should create an Extension
block only (EXT), Mailbox block only (MBX), BOTH, or neither (NONE). You may
also set which Subscriber Group (GRP) to create the block(s) in. This MMC is
broken into 8 sections as shown below. Each section defines which type of block to
make for each device as well as which Subscriber Group to create the blocks in.
NOTE: The STN GROUP category does not allow you to set GRP for station group
Extension or Mailbox blocks. All Station Group blocks will be created in
Subscriber Group 1.
DLI/SLI:
DESKTOP ITP:
WiFi PHONE:
SIP PHONE:
VIR. DLI/SLI:
S0 TERMINAL:
MOBEX STN:
[Applies to v.4.30 or Higher]
This section allows you to set the block structure for any DLI
or SLI extensions available in the OfficeServ 7100. By default
all extensions are set to BOTH with GRP set to 01.
This section allows you to set the block structure for all ITP
keysets connected to the OfficeServ 7100. By default all
keysets are set to BOTH with GRP set to 01.
This section allows you to set the block structure for all WIP
handsets connected to the OfficeServ 7100. By default all
handsets are set to BOTH with GRP set to 01.
This section allows you to set the block structure for all SIP
stations connected to the OfficeServ 7100. By default all
stations are set to NONE with GRP set to 01.
This section allows you to set the block structure for all
Virtual DLI and Virtual SLI ports available in the OfficeServ
7100. By default all ports are set to NONE with GRP set to
01.
This setting is not for use in the USA
This section allows you to set the block structure for all
MOBEX ports available in the OfficeServ 7100. By default all
ports are set to NONE with GRP set to 01.
Home Page
PROGRAMMING
PART 2 MAY 2009
USER OPTIONS
Table of Contents