Samsung OfficeServ 7100 Technical Manual page 426

OfficeServ 7100
TECHNICAL MANUAL
or FOLLOW INCOM DGT (MMC 724) when the MGI is used as a trunking
gateway.
• ALLOW GW CHECK: When using a gatekeeper, this permits the MGI to check
for gatekeeper presence. This parameter is set as ENABLE or DISABLE
PROGRAM KEYS
UP & DOWN
KEYPAD
SOFT KEYS
SPEAKER
ACTION
1. Press TRANSFER 834.
Display shows the first option.
Press UP or DOWN key to select an option
OR
2. Press RIGHT soft key to move cursor.
Press UP or DOWN key to select an entry.
3. Press RIGHT soft key to enter data and move
cursor.
4. Press UP or DOWN key to select an option
OR
Press TRANSFER to store and exit
OR
Press SPEAKER to store and advance to next
MMC.
DEFAULT DATA: GATEWAY CALL ID: 1234
H.323 FAST SETUP: ENABLE
CALLER ID TYPE: ANI
TUNNELING: ENABLE
DEFAULT DIL NO.: 5000
CODEC AUTO NEGO: ON
SIGNAL PORT: 10000
SEND CLIP TABLE: 1
INCOMING MODE: FOLLOW DID TRANS
ALLOW GK CHECK: DISABLE
MMC: 834
Used to scroll through options
Used to enter selections
Move cursor left and right
Used to store data and advance to next MMC
Home Page
PROGRAMMING
PART 2 APRIL 2007
DISPLAY
GATEWAY CALL ID
1234
GATEWAY CALL ID
1234
GATEWAY CALL ID
1234
H.323 FAST SETUP
ENABLE
Table of Contents